John Lewis SBSKITC Manuale Utente

SBSKITCSide by SideInstruction manual

10• Fix the joining bracket (11) with four 4.2x13 screws (3) using the holes in the top of the sides, see Fig. (12).• The bracket (11) must be positio

• If it is necessary to amend the level of the doors (only cooler and freezer units), partially unscrew the hingescrews, related to the door to be adj

• Position the top with the doors open so that the bottom front part fits under the top hinges, see Fig. (17)• Push the top so that its rear welt is t

• Fix the top frontaly with three M5X12 screws (1), see Fig. (20).• Fix the back of the top with four 4.2x13 screws (3), see Fig. (21).13

14• Fit the trims "18" between the units (freezer/wine cooler - wine cooler/cooler) by pressing along theentire profiles, see figure below.

15• Before proceeding with the fixing of (16,17) side strips remove the protective film.• Insert the side strip, see fig. (22) • Align the outside of

• Install the appliance.16You should also ensure that air can circulate freely around the back and the top of the cabinet.Position the assembled Side

17• After the positioning of the appliance, verify the door alignment.• If necessary regulate the rear feet and front feet to level the appliances. Se

18• How to adjust the door alignment.• Some examples are indicated in the figure under neath .

19• Before proceeding with the fixing of the plinth (15):- Remove the polystyrene protections with care without damaging the plinth, Fig. (31).- Remov

2Important information• Do not install the unit on your own or have unqualified personnel install it.• Improper installation may result in damage, mal

20• Fix the front of the plinth (15) with three M5X12 screws (1), see Fig. (35).

2221 062-0103/09John Lewis Partnership171 Victoria StreetLondon SW1E 5NNwww.johnlewis.com

3

4

5

6- Carefully place the unit on the floor, following the instructions on the packaging to make sure the unit isfacing upwards.- Open the bottom part of

7• Glue two spacer spongers on the right side of the freezer.• Glue two spacer spongers on both sides of the wine cooler.• Glue two spacer spongers

8• Bring the wine cooler unit near to cooler unit.• Only if necessary adjust the front feet so that the units are both the same height, see Fig. (6).•

• Repeat the operation between freezer unit and wine cooler unit.• Only if necessary adjust the front feet so that the units are both the same height,